Ford Puma Forum

All I was told it was a update for the speed sign recognition. When I got the car back I checked through the menu using the button on the steering wheel and tick some of the boxes that had become unticked while the dealer had the car.
All I can say is that everything seems to be working fine at the moment.
If I notice anything else I will leave another note.

pgc53 wrote: ↑Sun Jun 21, 2020 7:49 pm All I was told it was a update for the speed sign recognition. When I got the car back I checked through the menu using the button on the steering wheel and tick some of the boxes that had become unticked while the dealer had the car.
All I can say is that everything seems to be working fine at the moment.
If I notice anything else I will leave another note.

Any update on this bud? I've been using the intelligent speed limiter, which is quite handy as it will automatically set the limiter for you. You can set your tolerance +/- etc a couple of mph as you see fit.

All works well until it picks up a 20mph sign on a side street that you're passing whilst in a 30mph zone.

PCG how long did your update take ? ETIS is showing I have a update to that module available

Hi I took the car in to the dealer about 9am and picked it back up at 1pm but I had a phone call from the person doing the update and he said it had taken about 60 minutes to do.
Had no problems since.

Stevep999 wrote: ↑Fri Jul 03, 2020 11:26 am PCG how long did your update take ? ETIS is showing I have a update to that module available

Stevep how do you look at Etis please? Do you have full access or just the limited view. It shows my car as no campaign messages in the column on the left. Assume that means no updates available or required. Thanks.

My Etis is also showing nothing

I registered, its free. Look up vehicle software. Mine shows update available for IPMA module, last checked 12th March.

Interestingly it shows sync last checked 2nd July. It must check that wirelessly as no other way it connects

I took a trip to my office and back yesterday. 120 mile trip on the A1. National speed limit between Berwick and Newcastle. Out of nowhere, on a dual carriage way section that is 70, it was flashing 50!! Then out of nowhere n a section, it started flashing 40. There were no signs, nothing...

I think it uses a mixture of GPS data, your position and the camera. There have been other times that depending which direction you are heading on the same stretch of road, it will tell you either 60 or 30! I am pleased I found out how to take the audible warning off as it was really beginning to get on my ti...!

getting the IPMA update done this morning.....update to follow

So after update it picked up temporary speed signs it missed on way to dealers. Nationals all recognised as either 60 or 70 as appropriate, all seems good so far